Doesn't look like the last picture of the decal loaded so I'll try again
Had to do a little bit of work on the roof to get it ready to fit. I had several coats of UV resistant lacquer put on it but it had a few defects. Decided to smooth them out before fitting, easier place to get water while sanding was in the bath
Secure from the outside first...
Then from the inside to check its alignment
Had to mask the roof off to make sure I didn't get the sealant everywhere but the alignment still wasn't right
Simple ways are often the best
While the inside was secured an easy way too. You'll notice the aluminium blocks on the inside of the roof. These have been bonded and bolted to the carbon and drilled and tapped on the underside. I'll make and bolt 3 braces inside that will hopefully stop the roof from being pulled out by air pressure at speed.
Then taped up the inside gap to stop the sealant dropping through
Hopefully it will all be bonded in the next few days but this stuff was going off before i was finished! Not going to remove the clips and tape until Thursday just in case though, and then see if it's stiffened the roof. If not, I've got a plan to sort that later....