1.8vti Posted July 19, 2010 Share Posted July 19, 2010 got a apexi v-afc but can't found the diagram to install it , i think it's odb1.is it H3a on p.15http://www.apexi-usa.com/content/pdf6133.pdfthanks alot . Link to comment Share on other sites More sharing options...
tontvti Posted July 19, 2010 Share Posted July 19, 2010 In the honda Manual 11-B-17 to 11-B-19, pg 372Is the pin out for the PK9 ECU. The MB6 is querky as usual http://media.honda.co.uk/car/owner/medi ... 2s1e00.pdf Link to comment Share on other sites More sharing options...
1.8vti Posted July 19, 2010 Author Share Posted July 19, 2010 litte bit different then apexi web site Link to comment Share on other sites More sharing options...
1.8vti Posted July 21, 2010 Author Share Posted July 21, 2010 Can't find the rpm cable please help . Link to comment Share on other sites More sharing options...
civicturbo79 Posted July 21, 2010 Share Posted July 21, 2010 As long as you have the p9k ecu wiring diagram it should be straight forward . Link to comment Share on other sites More sharing options...
1.8vti Posted July 21, 2010 Author Share Posted July 21, 2010 I had read but didn't point out about it Link to comment Share on other sites More sharing options...
tontvti Posted July 21, 2010 Share Posted July 21, 2010 Right, I just searched the pdf manual for you, lol, page 1111 titled guages says says the tachometer (rev counter) shows 200 pulses of the ICM (ignition control module).THe ICM is pin 24 on plug AI just googled it and a few places say OBD2 ecus don't get an rpm signal, they calculate it from the (ICM pulses x 200) and that you can tap into the signal going to the rev counter.BUT the manual says the tach just outputs (200 x ICM pulses) Google HONDA, ICM, RPM.It seems to suggest ICM can be used for the rpm signalConfused, I am http://www.ek9.org/forum/other-technica ... ire-2.htmlHope this helps Link to comment Share on other sites More sharing options...
civicturbo79 Posted July 21, 2010 Share Posted July 21, 2010 There is an rpm wire 100% as i had one of these fitted i just cannot remember which wire it is , Rich. Link to comment Share on other sites More sharing options...
1.8vti Posted July 22, 2010 Author Share Posted July 22, 2010 connect engine rpm cable to ICM cable it's work fine now . thanks alot Tony.but next step is setting Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.