the mad kiwi Posted January 9, 2011 Share Posted January 9, 2011 the light has been since i realised the last owner had unpluged the light a while ago i pulled the codes RHR sensor so no biggie ,i replace it a few weeks back and still the light was still on after a bit of it looked like the pump/ecu so i found one of them and after a lot of its been replaced as well now things have changed b4 the light was on as soon as you turned the key now it thinks b4 it comes on but then doesnt turn off and now it wont give me any fault codes any ideas? or shal i just Link to comment Share on other sites More sharing options...
johngreen537 Posted January 9, 2011 Share Posted January 9, 2011 Hmmm. No error codes? You sure the ABS brain you bought is good? Link to comment Share on other sites More sharing options...
the mad kiwi Posted January 9, 2011 Author Share Posted January 9, 2011 yea i think its good there was no problems with the car it came from Link to comment Share on other sites More sharing options...
parkesie Posted January 15, 2011 Share Posted January 15, 2011 had every conceivable fault on a mk3 golf when the light stayed on with no fault another reset either cleared it or brought up the missing code.Good luck Link to comment Share on other sites More sharing options...
Guest Posted January 22, 2011 Share Posted January 22, 2011 im sure theres a sequence to clear the abs codes by pressing the brake pedal whilst bridging the contacts to get the codes if i come accross it again ill post a link for you mate. Link to comment Share on other sites More sharing options...
Guest Posted January 22, 2011 Share Posted January 22, 2011 here we go taken from ek9 forumIf you need to reset the abs light, try this:If your ABS light is on and you need to clear wheel sensor codes, follow these steps:1. Put a paperclip in the SCS connector (like you do to read the code)2. Hold brake pedal3. Turn key to position II4. When ABS light goes out, release pedal5. When ABS light comes back on press brake pedal again6. When ABS light goes out, release pedal once moreAfter a couple of seconds the light should blink twice, at that point turn key OFF and wait 10 seconds. Your codes are reset. Link to comment Share on other sites More sharing options...
shebabby Posted February 8, 2011 Share Posted February 8, 2011 here we go taken from ek9 forumIf you need to reset the abs light, try this:If your ABS light is on and you need to clear wheel sensor codes, follow these steps:1. Put a paperclip in the SCS connector (like you do to read the code)2. Hold brake pedal3. Turn key to position II4. When ABS light goes out, release pedal5. When ABS light comes back on press brake pedal again6. When ABS light goes out, release pedal once moreAfter a couple of seconds the light should blink twice, at that point turn key OFF and wait 10 seconds. Your codes are reset.hi all my abs light has been on a while now .iv tried to reset the faults by following the above but doesnt seem to work for me .is there owt else i can try . thanks !!nealy forgot its a 1999 1.8 vti mc2 aerodeck . Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.