civicboy Posted September 17, 2009 Share Posted September 17, 2009 right well because i started my job 2 week ago i was worth £1000 to a company from the jobcentre to help me get back into work. as a gift and because he is a multi-millonaire he has gave me the £1000 from the jobcentre soooooo its spending time what crazy aftermarket bits off other hondas will fit the mb6/mb2 pleaselist:coilovers - EK/EG ITR/ATR ???????rear lower control arms - EK/EG ITR/ATR ???????front upper strut brace - EK/EG ITR/ATR ???????front lower strut brace - EK/EG ITR/ATR ???????rear upper strut brace - EK/EG ITR/ATR ???????rear lower strut brace - EK/EG ITR/ATR ???????front anti-roll bar - EK/EG ITR/ATR ???????rear anti-roll bar - EK/EG ITR/ATR ???????front hubs (inc disc's and calipers) - EK/EG ITR/ATR ???????rear hubs -(inc disc's and calipers) - EK/EG ITR/ATR ???????plus any other bits pleasetom Link to comment Share on other sites More sharing options...
jalesi2001 Posted September 17, 2009 Share Posted September 17, 2009 Not 100% sure, but i dont think any of the above from the ATR will fit ours mate.. Link to comment Share on other sites More sharing options...
stubrun Posted September 17, 2009 Share Posted September 17, 2009 you can use the ek suspension but you will need the ek strut top bolts as the thread pattern is different, i would say accords are not compatible, the integra front suspension will work but the rears wont as the bottoms sit inside of the bottom arms, where as the m's are the fork type that bolt to the lower control arms. as for hubs my mate has converted his hubs on his mc2 to a 5 stud set up off a ukdm integra R. Strut braces from ek/ej's fit as i sold a mugen one off my 99 coupe to an mb owner, for suspension and brakes etc its good idea to look at the mg zs/rover set ups Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.