spudley1988 Posted June 6, 2015 Share Posted June 6, 2015 Apologies if it's an overly asked question but a chap is selling a set of xxr alloys which look similar to mini lites. Their 16 inch 8j and possibly et25. How would these be for whacking into mb6? Quote Link to comment Share on other sites More sharing options...
hondan Posted June 6, 2015 Share Posted June 6, 2015 Is say a roll on the rear arches and front liners out and a roll dependant how low you're going Quote Link to comment Share on other sites More sharing options...
spudley1988 Posted June 6, 2015 Author Share Posted June 6, 2015 Already reasonably low. Rolling arches a big job? Quote Link to comment Share on other sites More sharing options...
hondan Posted June 6, 2015 Share Posted June 6, 2015 No mate. I'd ask about for use of an arch roller if you want a seamless job.I've used electrical tape and a soft hammer before and it came out good, but I wouldn't recommend it.Here's a vid of the "proper" way: https://m.youtube.com/watch?v=rXm98bxAedw Quote Link to comment Share on other sites More sharing options...
spudley1988 Posted June 7, 2015 Author Share Posted June 7, 2015 Did it cost you much Tom? Quote Link to comment Share on other sites More sharing options...
KiNK43 Posted June 9, 2015 Share Posted June 9, 2015 Not going to endorse it because I've never rolled an arch. But the rollers can be bought for less that 50 quid on ebay aswell. Often tempted to have a go. I'm running a little negative camber would rather have a roll instead. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.