jocky2k Posted June 4, 2010 Share Posted June 4, 2010 Hey just wondering if anyone knows how theses would sit/fit on my mb3?? Link to comment Share on other sites More sharing options...
jocky2k Posted June 11, 2010 Author Share Posted June 11, 2010 Anyone got any ideas?? Link to comment Share on other sites More sharing options...
DAVEMB2 Posted June 13, 2010 Share Posted June 13, 2010 all i can say 17" will fit just not sure about the et38 Link to comment Share on other sites More sharing options...
GB. Posted June 13, 2010 Share Posted June 13, 2010 I presume they are 7inch wide, all I can say is mine are ET40(on a MB6) and I`ve had to raise it up a fraction(it was very low though) to stop them just touching the plastic inner arch,but I`m going to change the camber so its slammed to the floor Now Et is measured from the centre of the wheel to the mounting face,so a ET38 would be ok with less likely hood of wheel to arch contact. Link to comment Share on other sites More sharing options...
GB. Posted June 14, 2010 Share Posted June 14, 2010 I think I've got that the wrong way round, a higher ET number will tuck the wheel further under the arch, sorry Link to comment Share on other sites More sharing options...
jocky2k Posted June 16, 2010 Author Share Posted June 16, 2010 you sure coz surely the higher the et number the more the wheels moves out from the hub. i found a table that say our car takes a et or 38 to 45 so i should be ok i hope lol. Link to comment Share on other sites More sharing options...
Jason.s Posted June 16, 2010 Share Posted June 16, 2010 Yep, lower the offset the more it pushes the wheel out. The higher the offset the further into the arch the wheels sits. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.