Hop78 Posted September 1, 2013 Share Posted September 1, 2013 Can anyone tell me if the d16z6 engine loom will clip directly into the d14z4, wasn't sure if all I would need is the odb2a - odb1 jumper harness and wire the vtec in directly or if there is any other wiring to do? Just trying to cover all possibilities before I do the swap and then get stuck with it not starting.Cheers Quote Link to comment Share on other sites More sharing options...
Hop78 Posted September 3, 2013 Author Share Posted September 3, 2013 Can anyone tell me if the d16z6 engine loom will plug into a mb2 d14z4 or will it need modified or an adaptor harness fitted??? Quote Link to comment Share on other sites More sharing options...
KiNK43 Posted September 3, 2013 Share Posted September 3, 2013 At a guess id say 80% will work. You will likely have to extend o2 sensor wiring and some bits around the intake as it a different layout.As said just a guess, hopefully someone can give you a definate answer Quote Link to comment Share on other sites More sharing options...
Hop78 Posted September 3, 2013 Author Share Posted September 3, 2013 That already fits, I currently have a d16z6 inlet manifold fitted to the d14z4, it's just the wireing, wasn't sure if the engine loom will click directly in to the mb dash loom, struggling to find any info, seems like no one has done this on an mb before 😡 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.