nathan123487

Don't buy an eis one as the cap does not fit in them

How do I get the dome out for the remote central locking. I want to put it in another mb. The other one has a hawk kit fitted so will the dome still work or is the hawk kit going to interfere with it ?

Polak ?

Cheers krysz....... short for krysztof ?

Basically my door card is off and my door handle was just hanging there connected to a long metal bar that pulls which opens the door...... now my door handle will no longer hang there is it fell off..... I know that something has been lost or snapped.... I notice a green piece of plastic on the end of this bar... I believe a bit of this has broken off... am I correct. .... how can I rectify this ? As I am now stuck with the door card off and pulling the metal bar to get out of the car ? Cheers in advance guys

Ive took the door car off at the bottom of the door I notice two or three small drains. I notice when I wash the car the water rounds down the window into the inside of the door and out the bottom through these little drains. ... im guessing this is normal....

I'll take the door card off tomorrow and have a look inside I'll use some silicon round the windscreen

Ive found two leaks on in the top corner by the windscreen.... wet roof lining there. .... also waters coming through my drivers door speaker. Anyideas why this could be occuring

Weve had a lot of heavy rain lately here ive owned the car since September and it has been fine...... now I noticed that my drivers carpet is went and its not quite formed yet it doesnt have a sunrooof and the rest of the car appears to be dry. Any ideas where to start looking cheers in advance

Yea... they were plug and play in the end calibration is slightly more out than the ones I took out sat nav usually said 67 at 70 on the clocks ... with these it says 65 so nothing to worry about

it says here about recalibration... where can i do this properly if anyone knows i dont fancy moving the needles about maybe the scale of the numbers is going to cause an issue ?

http://civic5.com/forum/topic/2773-mb3-mb6-instrument-cluster/

how did you make that clock 24 hour ?

ive found a thread on here that i couldnt reply to so i had to make a new one basically im getting a set of these clocks later and im wondering what i will need to do to recalibrate them so my speedo and revolutions are correct ? the milage on them is the same as my existing milage

Ive got another set of clocks I needed for srs bulb. After taking these apart and having a look at them it I can keep my econo light by swapping the little chip over that holds the bulbs for abs srs econo.. also the front panel that says srs econo abs is interchangeable and the odeometer behind the speedo appears to be interchangeable too