Jump to content

Front control arm to wishbone specs

Recommended Posts

Hey all, I'm currently putting some hardrace components on my X plate (2000) fastback, 1.4 d14z4.

I didn't bother getting new wishbones for the front lower control arms, and have just taken them off the old control arms, given them a good clean with 240 grit sandpaper and a steal wire brush. New control arms and compliance bushing fit great, I have all the torque specs except for the single nut and the bolt that attaches the front lower control arm to the wishbone. Everything else is 47-66 ft lbs, so if I can ballpark it around there that's cool

Link to comment
Share on other sites

If nobody know's that I'm talking about I can provide a picture. It might also be referred to as an A arm? Not too sure

Link to comment
Share on other sites

Have you got a copy of the Honda workshop manual from the downloads section? All of the torque settings should be in there. 8-)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Recently Browsing   0 members

    No registered users viewing this page.

  • Create New...