noodels Posted April 7, 2012 Share Posted April 7, 2012 says you need to bridge ecu as it will show codes ect Quote Link to comment Share on other sites More sharing options...
noodels Posted April 7, 2012 Share Posted April 7, 2012 says you need to bridge ecu as it will show codes ect Quote Link to comment Share on other sites More sharing options...
civicvti Posted April 7, 2012 Author Share Posted April 7, 2012 And how do? Quote Link to comment Share on other sites More sharing options...
civicvti Posted April 7, 2012 Author Share Posted April 7, 2012 And how do? Quote Link to comment Share on other sites More sharing options...
Didjeridave Posted April 7, 2012 Share Posted April 7, 2012 Search 'read ecu codes' - but basically you connect a piece of wire between the two-pin connector near where the ecu is located (there's a two and a five pin conn, both blue). Turn the ignition key to on (don't start the engine) & the engine fault light will blink to give you the code. Quote Link to comment Share on other sites More sharing options...
Didjeridave Posted April 7, 2012 Share Posted April 7, 2012 Search 'read ecu codes' - but basically you connect a piece of wire between the two-pin connector near where the ecu is located (there's a two and a five pin conn, both blue). Turn the ignition key to on (don't start the engine) & the engine fault light will blink to give you the code. Quote Link to comment Share on other sites More sharing options...
civicvti Posted April 7, 2012 Author Share Posted April 7, 2012 But going around so could damage the engine? Quote Link to comment Share on other sites More sharing options...
civicvti Posted April 7, 2012 Author Share Posted April 7, 2012 But going around so could damage the engine? Quote Link to comment Share on other sites More sharing options...
steveolkinevel Posted April 7, 2012 Share Posted April 7, 2012 says you need to bridge ecu as it will show codes ect You will need to do two sets of pin bridges to enable it to work properly, one for the vtec and one for the iabs, i also think it will be limited to 115mph too! Quote Link to comment Share on other sites More sharing options...
steveolkinevel Posted April 7, 2012 Share Posted April 7, 2012 says you need to bridge ecu as it will show codes ect You will need to do two sets of pin bridges to enable it to work properly, one for the vtec and one for the iabs, i also think it will be limited to 115mph too! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.