aerodeckcrewser Posted April 25, 2012 Share Posted April 25, 2012 just had cambelt change pump thermo etc etc just went for a drive and temp gauge just shot up heaters blowin cold could there be air in rad ? wheres is the air screw ? Quote Link to comment Share on other sites More sharing options...
simpo Posted April 25, 2012 Share Posted April 25, 2012 Take off the rad cap to bleed it Quote Link to comment Share on other sites More sharing options...
aerodeckcrewser Posted April 25, 2012 Author Share Posted April 25, 2012 any guides at all cheers Quote Link to comment Share on other sites More sharing options...
aerodeckcrewser Posted April 25, 2012 Author Share Posted April 25, 2012 i think they have not bled cooling system properly Quote Link to comment Share on other sites More sharing options...
civicturbo79 Posted April 30, 2012 Share Posted April 30, 2012 There are no bleed screws and they are a pain in the a*s to bleed up , take it back to the garage and get them to sort it for you . Rich. Quote Link to comment Share on other sites More sharing options...
aerodeckcrewser Posted April 30, 2012 Author Share Posted April 30, 2012 All sorted Quote Link to comment Share on other sites More sharing options...
simpo Posted April 30, 2012 Share Posted April 30, 2012 Wat was it? Quote Link to comment Share on other sites More sharing options...
knight Posted April 30, 2012 Share Posted April 30, 2012 Wat was it?X2 Quote Link to comment Share on other sites More sharing options...
aerodeckcrewser Posted May 7, 2012 Author Share Posted May 7, 2012 just needed bleeding and they didnt put the temp to hot on the dial when they filled up Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.