Leaderboard

My D14 used to do this too! Lol can't remember exactly what the revs were at as it was an automatic, but if using the gearshift manually when giving it beans there was a distinct change of note from the engine. That wee engine used to spin up the revs really nicely.

And she's done it!! Finally got DD back on the road, passed her MOT on Wednesday with just an advisory on the n/s/f track rod end but knew about it before hand so going to get it replaced. So happy to be driving her again, been sooo long! Not got a photo as been constant rain here but here's a recent one for prosperity! Oh, roof rack is now off and her sunroof deflector is back on😃

Wow! That's a whole load of nice parts and work right there! Regarding the blow in the exhaust, the join either side of the CAT would be the first place to check imo. Could be the flanges are a bit crusty, so unless they gave it a good clean up first would most likely start blowing there. If you can get it jacked up high enough, could hold a small piece of newspaper at the joins and see if it "flutters" when it's running. Was the manifold already fitted prior to the rest of the exhaust or did they fit that at same time? Looking forward to the pics mate!

Yeah it’s nice! He did a 2inch cat back for me and welded on a backbox I already had, had a nicer bassy tone and seems to flow a little better which is nice! He wouldn’t cat delete it which is fair I can just do that myself when I get round to it, and all in all it wasn’t the most expensive job, was more than I wanted to pay if I’m honest, but a lot less than another place I had a quote from so I can’t moan too much right! Only issue is that I told him it’s blowing from somewhere I just don’t know where, and whether or not he actually checked I don’t know but he said he couldn’t hear or see it, yet it remains so I dunno. He said it could be the thickness of the Chinese manifold I have on, because it’s that thin it’s noisy, but I find that hard to believe if I’m honest. I don’t think it’s the manifold, I don’t think it’s where the mani meets the downpipe, so now that only leaves where the downpipe meets the cat. Hopefully when I decat it, it goes away then! Still got a huge parts pile to get fitted, managed to find a zs180 rear roll bar and all the fittings with it for quite cheap, new front wishbones and hard race compliance bushes, front ball joints, track rods, trailing arm polybushes, the 282 for the front and braided lines, the z6 intake mani and fuel rail, some Chinese ‘Bride’ universal seat rails to fit ‘Bride’ seats, coilovers, lca’s and toe arms. Think that’s about it…. Ooh and a new head unit haha. Annnnd new rocker cover and gasket when it gets here. Hmm, tegiwa brake stopper for the MC. Then I think that’s fully it! Got that different shifter set up all sorted too, not sure I’ve seen anyone else with it on as of yet? I’ll try get some photos and give it a little review. Fully worth it though, better than any generic short shifter / kswap replica ones that are about. Also that reminds me I have to fit the detent springs in the gearbox too…..