Jump to content

browniemb3

New Members
  • Posts

    26
  • Joined

  • Last visited

Everything posted by browniemb3

  1. Hi I believe my mb3 ignition barrel has warn out when you insert the it works fine till the final stage and the electronics won't light up without going straight to turning it over does anyone know someone who can repair it in the dery area thanks
  2. Hi I believe my mb3 ignition barrel has warn out when you insert the key it works fine till the final stage and the electronics dash etc won't light up without going straight to turning it over does anyone know someone who can repair it in the Derby area thanks
  3. Hi can a hand brake leaver on the rear caliper be repaired when it is stuck or is it best to get a new caliper
  4. Hi has anyone got a set of rear caliper bracket and pins for the 260mm disc near the derby area thanks
  5. Hi I'm looking for some advice on tuning my mb3 up a little exhaust /air fitter already done . I was tinking of gonig down thr line of a lighted fly wheel I'm really looking to try and increase low end torque first then not sure where to go from there.
  6. Hi I got few bubble out when I bled the system and the level has been dropping due to the lost of coolant from the rad cap scene found a small nick just under rad cap on the plastic sanded that down and now seeing how it runs if it leaks again
  7. Hi ive recently done a water change and flushed etc but since then the rad cap keeps leaking coolant when the engine has been ran for a while could anyone shead some light on why it's doing it thanks
  8. Thanks @Krzys I'll have q read and speak to him
  9. Hi could anyone tell me or direct me to ehter a site or forum page with the specification of the gearboxs ratio's for the d series engine as im looking to change my gearbox to get better acceleration without heavily effectine my eco on my mb3
  10. I'll look in to the sport cat i was told a 200 cell would be mot passable would i need to remap when i put 4-2-1 on to keep the eco I'll check ur build out thanks
  11. Ok thanks dave I'll leave intake lol what is the gear ratio like on the gearbox u mentioned as im looking for a 4-2-1 manifold and sport cat as i don't want to change every time for mot put not to mess up the eco need the mileage for work
  12. Hi dave ive done my air intake and i was taking to someone who said to try a 70mm throttle for better throttle response and maybe little more torque would it work
  13. Thanks grant daft q which bit would i need to measure lol
  14. Hi ive seen a mb1 with the 16 non vtec engine at my local scrappers and want to no is that the engine with the 70mm throttle body that would fit my mb3
×
×
  • Create New...