Muddyf Posted March 9, 2017 Share Posted March 9, 2017 Aerodeck MC1 went in for its MOT and JUST failed on its emissions, apart from a rear plate bulb that was the only issue. Engine management light has been on for a bit and upon checking reported as error P0131 - HO2S Low Voltage. My mechanic changed the sensor, reset ECU and the light goes out. During the test the light goes back on (within first couple of minutes) and the car JUST passes the emissions test (engine had been ran hard for a few minutes to warm up the lambda sensor for removal as it was refusing to budge shortly before). So after the test my mechanic looks at the problem, same error code - P0131. Whip out a multi-meter and check circuits etc using the workshop manual. 4 wire sensor Heater circuits work properly, continuity test on car side of 4 pin socket okay Sensor circuit appears okay, but does not have continuity on car side of 4 pin socket, is this normal? What else could be causing the problem? Is there anything else worth checking? Am i potentially looking at a new ECU? Quote Link to comment Share on other sites More sharing options...
simpo Posted March 25, 2017 Share Posted March 25, 2017 I would say it's still a sensor issues somewhere! How many do you have 1 or 2 what you mean about the 4 pin socket on the side? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.