lacos Posted October 12, 2010 Author Share Posted October 12, 2010 had comp test done and there is no abnormal difference between the four cylinders they were all 165 now i am not sure if that is in psi or bar what should they be . how much would it cost for a rebuild nothing fancy just slight over bore and new bearings and pistons , i am sure some thing is not right it just sounds strained and slow to rev up Link to comment Share on other sites More sharing options...
jalesi2001 Posted October 30, 2010 Share Posted October 30, 2010 It will be 165 Psi, 165 Bar would be fook loads!! Link to comment Share on other sites More sharing options...
james Posted October 30, 2010 Share Posted October 30, 2010 2393.127 psi to be exact Link to comment Share on other sites More sharing options...
mac2789 Posted November 3, 2010 Share Posted November 3, 2010 i would defo say it was your valve stem oil seals m8 i had the same trouble with my mb6 get them done and valves ground in re set your clearances and new gasket kit should be fine for another 100k Link to comment Share on other sites More sharing options...
johngreen537 Posted November 3, 2010 Share Posted November 3, 2010 x23! Spark plug seals in the rocker cover!If it were internal stem seals or oil seals, you be checuking oil into the combustion chamber and blowing it out of the exhaust on VTEC! Also, if oil O ring seals were gone, you'd notice wafts of blue smoke on throttle lift off. Get someone to look at the exhaust while you blip the throttle! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.