MBK89 Posted April 28, 2009 Share Posted April 28, 2009 Does anyone know how to remove the wooden veneer that runs along the dash in front of pass and the small piece by the drivers doorall help appreciado folks Link to comment Share on other sites More sharing options...
Dave Posted April 29, 2009 Share Posted April 29, 2009 The piece round the drivers side vent can be removed by very carefully prising it from the bottom, outwards, then the same at the top. Be very very careful, as theres chance the vent might break! The piece at the passenger side, I'm not sure. I tried to remove this in a scrappy, and and as far as i remember it's held with screws, though I could be wrong. The one I was trying to get out wouldnt budge and then broke Link to comment Share on other sites More sharing options...
jalesi2001 Posted April 30, 2009 Share Posted April 30, 2009 Carefully pry the trim panel (A) at the side edge, then pull it out, and disassemble the center air vent ( and side air vent ©. Installation is the reverse of the removal procedure. My internet died yesterday, but now im back to save the day!!!! Link to comment Share on other sites More sharing options...
jalesi2001 Posted April 30, 2009 Share Posted April 30, 2009 Opps, it didnt show you which is A, B and C!! Basically, the instructions say to start at the center end, (where there are two vents) and carefully pull it out, it is a real sod and stupidly tight so go steady but it does come out! Link to comment Share on other sites More sharing options...
Dave Posted April 30, 2009 Share Posted April 30, 2009 Nice one mate! Just an idea, but it would be good to put that in the how to section aswell. Every bit of info helps Link to comment Share on other sites More sharing options...
jalesi2001 Posted April 30, 2009 Share Posted April 30, 2009 Will do....! Link to comment Share on other sites More sharing options...
MBK89 Posted May 1, 2009 Author Share Posted May 1, 2009 cheers buddy! Link to comment Share on other sites More sharing options...
MBK89 Posted May 1, 2009 Author Share Posted May 1, 2009 did this earlier and was a hell of alot easier than i thought! Take out the cluster panel and then pull from that edge Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.