kyekye09 Posted March 24, 2012 Author Share Posted March 24, 2012 im not going to buy a brand new engine from honda to see if i get an extra 3bhp it was just tesco 95 mate Link to comment Share on other sites More sharing options...
650rob Posted March 24, 2012 Share Posted March 24, 2012 That's cool mate bet your chuffed. How much did rr cost you and where? We shoud meet up and go for a hoon on the coast road before you start your new project - what is your new project lol. Link to comment Share on other sites More sharing options...
kyekye09 Posted March 24, 2012 Author Share Posted March 24, 2012 That's cool mate bet your chuffed. How much did rr cost you and where? We shoud meet up and go for a hoon on the coast road before you start your new project - what is your new project lol.i got it dyno'd at car tuning clinic(not everybodies choice of rr but ive never had a problem with paul) and it only cost £55 for 2 runs... a wee run down bents mmm that would be cool bud as for the "NEW PROJECT" all im allowed to say is it will be a hell of a load quicker and handle alot sharper with a few choice mods mot expected from/for an M Link to comment Share on other sites More sharing options...
kyekye09 Posted March 25, 2012 Author Share Posted March 25, 2012 think im in this for the long run mate i just got my estimates in for the gearbox,engine and drive system on friday and its gonna cost a wee fortune i cant remember my ek being this much to convert into rally slag (not that im going rally mule with the deck though that would just be stupid) Link to comment Share on other sites More sharing options...
kyekye09 Posted March 25, 2012 Author Share Posted March 25, 2012 suppose i could model it on a safety car Link to comment Share on other sites More sharing options...
hickster Posted March 26, 2012 Share Posted March 26, 2012 An offroad estate? Nobody would be that crazy. Link to comment Share on other sites More sharing options...
Krzys Posted March 26, 2012 Share Posted March 26, 2012 They make them taller but they also make them longer too! Though they did reduce it from it's original length due to handling problems.... Link to comment Share on other sites More sharing options...
kyekye09 Posted April 23, 2012 Author Share Posted April 23, 2012 just a few pics of what ive been up to..... first of i finally got another z6 now the strip down std head and the block sump removed(for baffling) the crank will be lightend balanced and knife edged was going to use ycp vitara pistons(75mm) but decided to go with J E with a slight over bore(.25 over just to make sure cylider walls are free from scoring paired with eagle rods and acl bearings and supertech block guard and finally for now i managed to get a replacement rear arch so i can now chase out the dreaded rust Link to comment Share on other sites More sharing options...
noodels Posted April 23, 2012 Share Posted April 23, 2012 nice project Link to comment Share on other sites More sharing options...
kyekye09 Posted April 23, 2012 Author Share Posted April 23, 2012 nice project thanks bud Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.