ra272 Posted October 18, 2011 Share Posted October 18, 2011 Hello, is there any stiffness issue when using a 20mm MGZS rear ARB on a MB6?I don't want to see my chassis end like this: Link to comment Share on other sites More sharing options...
noodels Posted October 18, 2011 Share Posted October 18, 2011 looks like a corosion problem to me, and a crap repair to boot Link to comment Share on other sites More sharing options...
ra272 Posted October 19, 2011 Author Share Posted October 19, 2011 No one here had some cracks on their chassis after fitting the MG ZS rear anti roll bar ? Link to comment Share on other sites More sharing options...
noodels Posted October 19, 2011 Share Posted October 19, 2011 if fitted correctly and with the correct components/DROP LINKS ect so under no increase of stress issues to OEM have never seen an problem.it is a tested part on mg roveras honda.And as said your chassis has exsesive corrosion and need correct repairing as is unsafe and would be deemed unsafe in uk and would be taken of the road for the above reasons,ie dangerous for use on public roads.so my advise is to repair correctly mate Link to comment Share on other sites More sharing options...
james Posted October 19, 2011 Share Posted October 19, 2011 thats ott Link to comment Share on other sites More sharing options...
ra272 Posted October 19, 2011 Author Share Posted October 19, 2011 if fitted correctly and with the correct components/DROP LINKS ect so under no increase of stress issues to OEM have never seen an problem.it is a tested part on mg roveras honda.And as said your chassis has exsesive corrosion and need correct repairing as is unsafe and would be deemed unsafe in uk and would be taken of the road for the above reasons,ie dangerous for use on public roads.so my advise is to repair correctly mate Thanks for the advice; btw it's not my chassis on the horrible picture above.Here is a picture of my chassis,I only bought the MG bar, so I used original MB6 L brackets and drop links. Link to comment Share on other sites More sharing options...
simpo Posted October 19, 2011 Share Posted October 19, 2011 you wanna get the mg drop links better imo Link to comment Share on other sites More sharing options...
noodels Posted October 19, 2011 Share Posted October 19, 2011 sorry mate thought it was yours as the dampers looked the same,see the springs are black on the one you posted first. Link to comment Share on other sites More sharing options...
weetec Posted October 19, 2011 Share Posted October 19, 2011 Hello, is there any stiffness issue when using a 20mm MGZS rear ARB on a MB6?I don't want to see my chassis end like this:your not alone with this one...happened to my last M too...quoted stupid money for repairs as fuel tank had to come off... Link to comment Share on other sites More sharing options...
noodels Posted October 19, 2011 Share Posted October 19, 2011 something to look out for then chaps must be a design fault better fill mine with oil and let it drain Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.