Leaderboard

Its been a long time since the last update. So yeah of course it is fully wrapped now by myself and lowered even more. Looks pretty good but for sure sometime in the future I might paint it (I'm currently doing car painting education) plans for the future: Turbo... I found a cheap kit on marketplace and then I'm gonna try and make a reliable stock internal setup, so not that high boost

Managed to get the tank out and in at the weekend with surprisingly little drama. Plenty of WD40 and the impact gun on the nuts got them going. From there I just followed the instructions from the service manual without any major difficulties. Tank was very dirty with some surface rust but under all the grot it was in perfectly good condition. Gave it a quick clean off with some WD40 and a wire brush. I am lucky to have access to a 2 post lift.. I can't imagine trying to do this on axle stands. I the fitted the following walbro 255LPH fuel pump that I purchased from Tegiwa https://www.tegiwa.com/products/walbro-255-fuel-pump-kit-honda-civic-eg-ek-integra-dc2 Forgot to take photos of the important bit, the pump... But in summary, it's almost a "plug and play" swap - the electrical connector was the same, only thing I really had to do was trim a little bit off the rubber hose that fed the pump as the body of the walbro is longer. I also opted to use the original filter "bag" from the stock pump as it was a different size/shape to the new one that came with the walbro and I read an old post on here from someone saying they fitted one with the new bag and the car ran out of fuel at 1/4 tank so I didn't want to risk it! Tank reinstalled and the car fired right up with no signs of leaks, glad that job is off the list. It's still a complete mystery to me why there is no access hole especially as there's a hole on the other side to get to the level sender! I was almost tempted to break out the hole saw and make one.. Weve currently got an issue with the engine overheating, I am hoping it's just an air lock (I've heard k24 swaps can be notorious for this as the radiator fill point is lower than a lot of other components as the engine sits a bit higher than the d series would've done), and we have some funky shape hoses. I've tried massaging the hoses and jacking the front of the car in the air to no avail. I've bought cheap a vacuum coolant filling kit that you hook up to an air compressor from Amazon for £40 so will see how I get on with that... Fingers crossed that sorts it.