Leaderboard

Today i went to get some Sheet metal to start fabricating the inner/lower sill sections Hoping to borrow a metal bender on tuesday so i can get the Shape right, for those all wondering i got 1.5mm steel which is around the same thickness that Honda used for the inner/lower section of the sill it seems to be an easy shape to make thankfully i had a small piece of Sill from a donor car which helped me with the measurements. for those who are wondering the Sill comes in 3 segments, for the time being im making the middle section which is shown on the diagram the dimensions of the middle sill i have done them at: L: 1200mm W: 240mm Thickness 1.5mm Then there is the Front section which houses the outrigger and jacking point, this bit is way more complex as the pressing contains sections of the chassis rail and inner wheel arch this bit is usually where the rot starts at the seam where the front floor meets and is sandwiched together with three layers of metal. For this bit i will tackle it by just fabricating a piece which fits just the area i need as the rest of the outrigger seems to be perfectly fine thankfully. And Finally there is the Rear section which is the extension piece which houses the rear jacking point, and Trailing arm Mounting point. There was in fact a NOS Rover 45 panel for this online however sadly i was unable to grab it in time, that or it was an old photo that i found of an old ebay advert. But still allows me to get some sort of knowledge on how it is shaped and what panels are missing on my civic due to them rotting away. Thankfully on my Civic the backside of the Sill isnt rotten at all, just a few surface blemishes, so really i just need to cut out the bottom section of the sill and weld new in there alongside a new reinforcement piece which helps with the weight of the jack. This panel is fairly complex as it interlocks with the middle section of the sill and is then spot welded together but thankfully i wont have to mess around with that bit as the rot doesn't spread that far up the sill. Im looking forward to getting these panels made up as once that is done then i should fingers crossed have all the panels i need for welding, (thats until i probably find more rust) Needless to say its a huge project however it will be very worth while when its done.