Grant Posted April 25, 2014 Share Posted April 25, 2014 Good thinking Quote Link to comment Share on other sites More sharing options...
Krzys Posted April 25, 2014 Share Posted April 25, 2014 I take it the second valve that needed doing was on the same side of the same cylinder was it? Glad to hear the pulley bolt finally shifted! Mongo strength Quote Link to comment Share on other sites More sharing options...
marv Posted May 2, 2014 Author Share Posted May 2, 2014 Wee update... Just picked my head up from the workshop it's had a very minimal skim,two new exhaust valves,new stem seals,pressure tested and chemically steam cleaned. They also ordered me in new oil and filter,timing belt,tensioner,water pump and a full top end gasket set. Hoping to get on it this weekend if I can set aside some time.Also bought some yellow film for tinting my fog lights. Still not sure if I like the mesh grille, think I prefer the standard slatted grille.Hopefully more updates over the weekend. 1 Quote Link to comment Share on other sites More sharing options...
Krzys Posted May 2, 2014 Share Posted May 2, 2014 Sweet! Hopefully you'll be able to get it all back together over the weekend then?! Great stuff! Quote Link to comment Share on other sites More sharing options...
Grant Posted May 2, 2014 Share Posted May 2, 2014 Loads of work to do there mate!! Should run sweet as a nut once your done though Best of luck. Quote Link to comment Share on other sites More sharing options...
marv Posted May 3, 2014 Author Share Posted May 3, 2014 I'm hoping so guys! Iv got Monday to myself and il try find sometime today and tomorrow. Wanting to take my time and make sure I do it all right. Quote Link to comment Share on other sites More sharing options...
vtec2011 Posted May 3, 2014 Share Posted May 3, 2014 Cool! Not long now till it's back on the road for some vtec'ing Quote Link to comment Share on other sites More sharing options...
marv Posted May 3, 2014 Author Share Posted May 3, 2014 Hoping so! Managed to get the valve train assembly fitted today, got the head fitted and all torqued down aswell. Hopefully get time tomorrow to get cams fitted and the timing belt on, then got the inlet to refit which should be fun. Quote Link to comment Share on other sites More sharing options...
NIKH25 Posted May 3, 2014 Share Posted May 3, 2014 All coming together then. Quote Link to comment Share on other sites More sharing options...
Krzys Posted May 3, 2014 Share Posted May 3, 2014 Getting there dude! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.