Leaderboard

So an Update on the Lower Sills I Managed to cut them out the other day, i got all the pieces i needed to create the sections that are required. As shown i used the existing cutout to get the shape of the sill, for the Rear Extension piece and also the mid section The welding course that i was doing said that we are able to do a project in the last lesson, so i used this time to start bending the metal to the profile that i need for the lower sill. This saved me buying a Metal bender that fit the requirements for the job as i needed one that was capable of bending 1.5mm steel and the length had to be 1200mm or more for the mid section if i was to buy one like that youre looking at £1000+ for a decent one that will last you. So here are some images to show the final product really chuffed with how they have turned out, they do require an ever so slight bit of fettling to get right as the profile of the back part actually isn't straight however it comes in at an angle then straightens out when it gets to the wheel arch There are a few other little panels that i still need to fabricate such as the panel that joins the wheel arch to the sill and also the jacking point reinforcer that sits inside the sill. These will all be made in due time. I then offered it up to an existing panel to see how well it fits into place, and to be honest i was surprised how well it did! After all the Testing of fitments and other things i thought nows the time to get them protected so they dont rust. I keyed the surface and made sure that the panels were clean from dirt, rust and residues and then used some Bilt Hamber Electrox Zinc primer. Coated them twice to make sure there is a good layer of protection. Overall im chuffed with the outcome, who knows i may end up getting a Metal bending machine and start making repair panels for these cars lmao certainly ideal as a lot of the panels that are out there for these cars aren't the best.

Good stuff