Aerokek Posted May 10, 2021 Share Posted May 10, 2021 (edited) Started with a little experiments a few months ago, just something to keep me busy in between jobs etc. Started out with an extra stock lid that goes on top of the trunk. Added a piece of plastic to lengthen it, melted it to shape and filled it with expanding foam This was still super experimental, started to cut the foam to shape but to start over since I wasnt satisfied with the basic shape. Also the third brake light position wasnt much to my liking. So back to the drawing board! Felt it was too short to, so I extended it using a Citroen C3 rear wing thingy. This was long enough, so I was off to shaping and smoothing filled everything up, fill, sand, repeat. sprayed some primer on it, more sanding. Tried to use lines to get it as closely symmetrical as I could. Now I needed to fill in the underside too, I've kept the third brake light in its original location. Used foam and glassfibre to create a strong base. Again, loads of sanding and filling to get everything nice and smooth. Almost there! Have to figure out a way to shape the surrounding filler to fit the third brakelight nicely. Edited May 10, 2021 by Aerokek 3 Quote Link to comment Share on other sites More sharing options...
dr_broon Posted May 10, 2021 Share Posted May 10, 2021 Nice bit of modding there matey Be good to see how it turns out. 1 Quote Link to comment Share on other sites More sharing options...
Dave Posted May 10, 2021 Share Posted May 10, 2021 Thats a totally amazing bit of work mate, loving that! Will be following this one! 1 Quote Link to comment Share on other sites More sharing options...
dan1 Posted May 12, 2021 Share Posted May 12, 2021 Great work, proper interesting stuff! Looking forward to seeing it complete with paint on it! 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.