Jump to content

My Civic MB2 Project! Discs and pads needed!


fyfie5
 Share

Recommended Posts

also a nice tank cutter hole in the bumper should be good to get the cold air to the filter

think i could feed it through to where the foglight is meant to be? and what would i need to do that?

Cut the blanking holes out. Loads of good work going on here, keep it up mate. :D

Link to comment
Share on other sites

My filter is in the same place and I have never had a problem. I have went through some deep puddles and its been alright. So its not as bad as people say.

Ah cool that gives me peace of mind now :lol: but think I'll still check it every so often just incase

Link to comment
Share on other sites

My filter is in the same place and I have never had a problem. I have went through some deep puddles and its been alright. So its not as bad as people say.

yea x2 dont worrie about it bud, ive drove though water up to the lip of the bumper and it was fine, if you drive through water deep enough to hydro lock it my guess is youve ran into a lake! :shock:

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...