markez78uk Posted May 8, 2011 Author Share Posted May 8, 2011 like i said mate check the code as should tell you wats wrong then you can get the part and off you goyour a legend its givin 1 long 5 short (15)ignition output signal now the hard part what does that meantop man cheers fellaalso my battery seems to be nearly flat hope this helps Link to comment Share on other sites More sharing options...
markez78uk Posted May 8, 2011 Author Share Posted May 8, 2011 sorry to be thick but what codes would my car be using a 98 r reg is it ob1 or 2 ? Link to comment Share on other sites More sharing options...
simpo Posted May 8, 2011 Share Posted May 8, 2011 think its something to do with the dizzy check the plugs see if there is any lose wires etc Link to comment Share on other sites More sharing options...
johngreen537 Posted May 8, 2011 Share Posted May 8, 2011 Wiring issue in the dizzy I'd say mate.Does the Blk/Yel wire (in the dizzy connector)have power with key in Position ON(II)?Does the Yel/Grn wire running between the dizzy and ECU have power? What voltage does this wire have at the dizzy with the key in ON(II)?I'd bet one of those two! Link to comment Share on other sites More sharing options...
jalesi2001 Posted May 8, 2011 Share Posted May 8, 2011 Probably igniter in the dizzy or the main relay, that's what it normally is on our cars! Have a look in the manual mate, it will tell you what the fault code is and how to diagnose it! Link to comment Share on other sites More sharing options...
bepilot Posted May 10, 2011 Share Posted May 10, 2011 I bet it's the distributor. Had a similar problem.+1 but no ECU faults for me, depends what goes wrong in it - i didn't take the risk to replace just cap and rotor, I decided for an aftermarket GS-R one (TD-81U - 110eu shipped) and it instantly worked.My symptoms were: stumbled in low revs when warm, very difficult to keep the engine from starving - nearly impossible to start up then, after 3000rpm it was going allright. Link to comment Share on other sites More sharing options...
KiNK43 Posted May 13, 2011 Share Posted May 13, 2011 common problem then these dizzys failing ay.so you got to the bottom of it. replacement dizzy? Link to comment Share on other sites More sharing options...
markez78uk Posted May 16, 2011 Author Share Posted May 16, 2011 waiting on my garage to have a lokk my battery failing 2 grrrrr Link to comment Share on other sites More sharing options...
markez78uk Posted May 25, 2011 Author Share Posted May 25, 2011 still no joy at the mo awaiting on garage to get back to methere taking ages how do u check the dizzy wiring ? Link to comment Share on other sites More sharing options...
stubrun Posted May 25, 2011 Share Posted May 25, 2011 check the wiring on the plugs next to the distrbutor itself and with a multimeter check the feed. i had this problem with a b16 conversion i did and it was the ignitor at fault, i swapped it with one from a d15b7 and it worked fine as said its a common problem. stuart Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.