Does MB6 exhaust fit MB3?

[h4mza]

I want the Toyosports exhaust for MB6 on eBay but don't know if it will fit the MB3 as both are different engines. How do I find out?

[MB3Matt]

Exhaust mani is different I think. So I would say no, it wouldnt fit. I may be wrong.

[NIKH25]

You're exhaust bore is smaller than MB6 so no it won't, you'd have to start by replacing the mani for one with the same size collector as MB6 (1.7" iirc) then use an MB6 cat or decat.

[Roj]

You could always ask an exhaust shop to adapt the Toyosports system for the MB3 manifold.

[Mr Brown]

MB3 mani would need to go as it is a catifold (manifold and cat in one) not a manifold so Sir Little Nick Esq's suggestion sounds the best route..

[DAVEMB2]

You get a japspeed 4:2:1 mani and get the mb6 one modded with cat or decat

[h4mza]

You get a japspeed 4:2:1 mani and get the mb6 one modded with cat or decat

I was thinking of the 4.1 manifold instead because I want that Subaru burble. So if I get Japspeed 4.1 manifold and Toyosports exhaust system, will that be a direct fit?

[DAVEMB2]

I take it the toyosport is for a the lower Mbs if its for mb6 it may still be bigger ,that said even with that set up you going to need a decat pipe or the cat coz there would be a gap where the cat should be . Cat system would be cat back and on the mb3 the cat is on mani mm so what you could do is get a custom decat pipe made to match both sizes up and fit that in between mani and system .

[h4mza]

Ok thanks, I might just get a custom made exhaust instead.

[simpo]

Will you get that burble on a mb3?