bitkar

link to the full album https://photos.app.goo.gl/nP1C951Gxi8voy1H6

that looks brutal.... do you have turbo at least? :) looks like a racecar 300 HP at least

ok, its been some time... but i want to share few photos from a civic photoshoot i made recently. This is how it currently looks like.

you have to pull the tab on the short side and then pull it out. Just for the case someone goes by. I had the same issue :)

Hi, iam glad this forum still exists... if you need to upgrade your headlamps... I wanted to show you what i did... basically ebay retrofit kit. So ya, it fits nicely, there is how it looks. https://www.ebay.com/itm/Auxbeam-H1-LED-Headlight-Hi-Lo-Driving-Bulb-70W-7000LM-6000K-Decoder-Replace-Kit/153614622461?hash=item23c4251efd:g:44gAAOSwvNhdS8jZ https://www.ebay.com/itm/HID-Bi-xenon-Projector-Lens-LED-Square-Angel-Eyes-For-H1-H4-H7-Car-Motorcycle/372702246099?hash=item56c6c8f4d3:m:mBnGfFGoBxmiVNW5LRyRKng I hope i saved you some thinking :) I do not have a review, i just installed it and it shines ok, but i need to adjust it properly. But its way better than old style original lights for sure! The rings are DRL (controled by first position on lights swithc - parking light) and those switch off when you go for regular lights.

Hey iam here again, couldnt find my old topic tho... what happened? I just did some trackday after few years. Finally with MeisterR and everything o modded on my suspension. And iam happy. It works.. the second session was on stiffest (rear +5 to softer) and it was good. Its more oversteery. I still think its better to have 8/5 springs than 8/6 btw. I would like to test it how that works. Maybe I will try to get different springs to back, little softer. So I will post the trackday videos here and I also done some roadtrip around Bohemia with my Civic. Its a big project, so it will take time to make the documentary, but i will post it here too, so you can see how my country looks like from an MB6 seat enjoy the videos (only 2 because I ran out of brakepads )

hey, i just want to note that I bought BLOX and iam happy so far. Works as expected. If needed you can buy and replace the ball joint, which is good too.

Try to find some right for MB6. MeisterR makes them. I know some BC racing can fit (maybe with minor adjustment). Not sure, but rear end should be the same as integra... somebody can confirm or otherwise... Front should be ok any (EG, EK, DC2), try to confirm that yourself, dont rely on me tho.

Hi, I already know that on MB6 I need camber arms from EG and DC2. But what brand/make? What did you buy and how satisfied are you? I saw D2s are quite cheap, are they bad in any way? how about Buddy Club, Hardrace, Skunk2? Are they any better? What in particular is better? Thanks for you suggestions