DAVEMB2

I would say inside tank could be bad mine look perfect outside but if its had anything put in it or been ran very very low ,or like mine had been left dry for any sort of time in its life then it's going to be like mine was . You may as well at least try give to tank a flush and check pump and strainer or you well just pull all the shxt back to your filter and injectors . That why I am not running trinity to far at mo till I can switch tanks and bits all nice and clean

Arrr what a pain mmm just been back reading ,you say when you took the fuel filter off ( in the engine bay ) it was brown like a rust ? Coz that is what has been wrong with trinityD ,that's why I have new fuel tank ect. Good chance the fuel pump strainer is clogged up to and your tank is rusting . When I dropped mine it had about 10-20mm of rust mucky shxt in the bottom and the strainer was pretty shit So you may need to do a full fuel clean from tank to injectors what a bummer

Looks clean nice and some good plans you have

Odd wiring can be a pain I stil have to find out why the heater blower on trinityD is not working and it's not the Rez pack lol

Just can not get time off work that's my prob in the summer time it's a pain and there are no shows in winter

No sure ran her at dynodaze at a c5 meet I would say £25 + for a run or two

Arr that's just a bummer

I think prob custom best bet

I think mrB if you doing a rebuild I would go for a new box with LSD new clutch and blow a 1.5 that would be well diff and cool oops I may of let something out lol

Yer the dam cat on the mb3 makes a big diff I have an s20 box but not got it on yet

Ok just add to the door cards got some the vti tweeter pods so they have just gone carbon lol Now I had got new fuel tank as you may of seen so need to under seal it before it goes on mmmmmmmmmm. So I have but just not good old black lol so when it's up on ramps you can go oooo I like that lol lol bit OTT but she got to look good under to . . Just got a get a few bits before it goes on the car but they should be on the way

Looks sweet nice work

Nice bit of work going on its good to get the little things done

Sarah's hard cracked inside she had a slow puncture so did not see it until had tyre off

5 stud James and she gone to 16"

It's a vid lol and not had chance at mo that said the weather has been dam xxxx . Need to sort my fuel tank and sender but its all in hand so clam down lol lol

Dam same thing happened to Sarahfr Dam pot holes. Arrrrrrrrrrr

X2

Are but you have had a video

Ok to the new year it's time for a new bit carbon what else lol DAM PHOTOBUCKET WHATS THIS NEW XXXX ALL ABOUT LOL

He may not have on the mb3 the fuse is ok ?

Yer that's right tom ,best just get The lot all fixing bits lol that way you will have what you need

It's always best to give them a run or to even in winter . Unless you have a place to keep them warm like big boss Dave

It's what the seat locks into if you get me

As far as i can Remember It's the metal bracket like bits you no when you clip the upright seat to lock them up they are like hook that are fixed to the sides .