Jump to content

dr_broon

Administrators
  • Posts

    6,019
  • Joined

  • Last visited

  • Days Won

    322

Everything posted by dr_broon

  1. Good work And a nice shiny engine at the end of it all as well
  2. 7 degrees is what I'm keeping an eye out for. From the last couple of days it would have been this weekend, but it's getting back up to 13 tomorrow
  3. Crap.. Are you guys okay?
  4. Credit card bill? Is it for inside, outside or oomph?
  5. And anal shabangs.. Looks tidy does that though.
  6. See about halfway down this page for when i got them and fitted http://civic5.com/forum/topic/1401-dr-broons-vti-deck/page-2
  7. Holy moly! Bit of alpha grill going on there
  8. I know that we've been pm'ing about the spacers but just seen this thread. To be honest if try what @noodels suggests abs try with your original springs. You'll still get a drop over standard coz the konis all seem to be lower at the front (including the springs... I Remember @james had the problem with his springs) I have always wondered what the ride would be like with the standard springs and better shocks coz I've always suspected the shocks are the real weak link. I've got eibach pro springs and the front was low with the konis... This is the same setup that s88hon had, hence me nabbing his spacers when he didn't need them anymore.
  9. Quite like the front, less sure about the side skirts and not a fan of the rear lip bit.. Looks pretty mean though
  10. dr_broon

    K24 EP3

    Sounds like it's a beast.
  11. No.. Must have been thinking about another part for the honda reference. Was this page, but says no longer available http://www.rimmerbros.co.uk/Item--i-GRID003514
  12. Pretty sure that the tanks are different as ours have two holes and the mg just had the one. Not sure about the fuel lines... Was looking into it recently, and although they look similar from the diagrams on lings website and in rimmer bros, you can't really tell, and Rimmer bros were showing that they were out of stock anyway. Actually, rimmer bros might have referred to it as a honda part?.... Will check.
  13. Can we get a hundred mile countdown once you get to 1k left?... 900, 800, etc?
  14. Both look like they have the same part number on lings bud
  15. I got a second hand one off @10000rpm I'm sure he'll have one available.
  16. That's poo that it's not covered under the warranty... Hope you get to the bottom of it without too much disassembly.
×
×
  • Create New...