Jump to content

Chandler

Civic5 Supporter
  • Posts

    9,832
  • Joined

  • Last visited

  • Days Won

    177

Everything posted by Chandler

  1. sorry guys. these need to be kept secret till everything is in place. it's something different to say the least
  2. haven't updated for a while as i've been busy saving. picked up some sexy parts from Hond-R today. should be ready for mimms in april
  3. should last a while mate spray some WD-40 on it every so often
  4. Chandler

    MB6 Bracing

    it might fit with the little modification. I think the strut tops are slightly off/twisted more. I could be wrong though
  5. mate that'll be fine. all the water would do Is slowly put a layer of corrosion on the bare wire. I wont stop it from working being wet. but if you want a permanent fix get a proper connector as said above
  6. @m0l0t0v i might have replaced the one with the groove in for the circlip. can't remember i did it nearly a year ago and didn't take any pictures of mine
  7. i replaced number 4, 6 and 7 from below number 15 below number 12 from below
  8. the flywheel bearing you on about ye? is the engine/gearbox standard for your car? if so if you give me the reg i can give you the honda part numbers. did they send you genuine bearings?
  9. have to order them in. also i don't know. i don't usually pay honda prices
  10. Chandler

    No warm air

    @willwroe if you put the fan onto the windscreen. then put the fan on hot and onto number 4 speed once up to temp you should get some hot air coming up onto windscreen. but it sounds to me that the flaps inside aren't moving
  11. Chandler

    No warm air

    ah should be an easy fix. that'll be a new heater resistor if the fan doesn't work on all settings
  12. Chandler

    No warm air

    have you tried the fans on all settings and the blower works? also have you tried the blowers on all settings, ie feet, windscreen, face etc. I had the same problem with mine only blowing out cold air from the centre vents. turns out the cable wasn't turning properly and one of the flaps wasn't turning enough. best thing to do is to remove your heater box from behind your glovebox. then test the switches/ dials to see if the flaps are moving properly
  13. If you were closer I would've came and helped man. Didn't take me long to do mine. Plus I got mine from honda. Only replaced 2 bearings
×
×
  • Create New...